Ultrasonic Level Indicator

Tank Level Measuring Made Easy.

A single measuring device that can be used in virtually any tank.
Negates the need to stock and use multiple types
of vertical and horizontal probe sensors for different tanks.
Provides a wide range of outputs suitable for use with most common meter brands.
Easy to fit, extremely accurate and no moving parts.
Much more reliable than devices such as float sensors which are prone to getting jammed.

Works with petrol, diesel, fresh water, grey water and black water.
Can be used with both metal and plastic tanks.
The Ultrasonic Sender is a revolutionary breakthrough in measuring levels in virtually any type or shape of tank.

It solves a complex problem that in the past, lots of different sender solutions were needed for different tanks. This meant that tank users and manufacturers had to stock a vast number of sender variants and specifying was complicated. The Ultrasonic sender can be used in ANY tank between 200 and 2000mm in depth and it is compatible with virtually any meter head type.
The TS1 must be mounted 150mm away from any tank wall or vertical baffle. It works by using ultrasonic waves to measure the fluid level rather than relying on senders either sat in the fuel, on-top of the fuel or installed at different heights through the side of the tank. The unit is low profile and uses an industry standard SAE 5 stud mounting pattern with a gasket seal and washer and can therefore be easily retrofitted in the place of existing senders as well as used for new fits. The Ultrasonic sender is pre-programmed for linear tanks to 2 meters in depth and with a 0-5 volt output. For nonlinear tanks and different outputs, Tek Tanks can pre-program units for customers. Alternative outputs of 10 – 180, 10-300, 240-33 are available.  

If Calibration is require please call us with the following information:
*Tank Contents
*Output US or European
*Tank Dimensions
*Wall Thickness of Tank