After being asked for some time now if we could supply the incredible BEP Marine TS1 Ultrasonic Sender, we have decided to go ahead and stock this item.
- The TS1 is capable of sensing water, waste, petrol and diesel in polyethylene, aluminium, stainless steel and fibreglass tanks.
- Once programmed by Tek-Tanks the TS1 is easy to fit, extremely accurate and no moving parts.
- Much more reliable than devices such as float sensors which are prone to getting jammed.
- Works with petrol, diesel, fresh water, grey water and black water.
- Can be used with both metal and plastic tanks.
- The Ultrasonic Sender is a revolutionary breakthrough in measuring levels in virtually any type or shape of tank.
It solves a complex problem that in the past, lots of different sender solutions were needed for different tanks. The TS1 sender can be used in ANY tank between 200 and 2000mm in depth and it is compatible with virtually any meter head type. The TS1 must be mounted 150mm away from any tank wall or vertical baffle. It works by using ultrasonic waves to measure the fluid level rather than relying on senders either sat in the fuel, on-top of the fuel or installed at different heights through the side of the tank. The unit is low profile and uses an industry standard SAE 5 stud mounting pattern with a gasket seal and washer and can therefore be easily retrofitted in the place of existing senders as well as used for new fits.
The Ultrasonic sender is pre-programmed for linear tanks to 2 meters in depth and with a 0-5 volt output. For nonlinear tanks and different outputs, Tek Tanks can pre-program units for customers.
Alternative outputs of 10 – 180 ohms, 10-300 ohms, 240-33 ohms and 1-5 volts are available.
Download Installation and Operating Instructions Here
